Dell Force10 S4810P, Reference Manual

Page: 1305 / 1637

Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1 Introduced on the E-Series.
Usage
Information
NOTE: Per Port rate limit and rate police is supported for Layer 2 tagged and untagged
switched traffic and for Layer 3 traffic. Per VLAN rate limit and rate police is supported on
only tagged ports with Layer 2 switched traffic.
C-Series and S-Series
On one interface, you can configure the
rate police
command for a VLAN or you can
configure the
rate police
command for an interface. For each physical interface, you can
configure three
rate police
commands specifying different VLANS.
E-Series
On one interface, you can configure the
rate limit
or
rate police
command for a
VLAN or you can configure the
rate limit
or the
rate police
command for the
interface.
For each physical interface, you can configure six
rate police
commands specifying
different VLANS.
After configuring VLANs in the
rate police
command, if this error message appears:
%Error: Specified VLANs overlap with existing config.
check to see if
the same VLANs are used with the
rate limit
command on other interfaces. To clear the
problem, remove the
rate limit
configuration(s), and re-configure the
rate police
command. After the
rate police
command is configured, return to the other interfaces
and re-apply the
rate limit
configuration.
Related
Commands
rate-police – specifies traffic policing on the selected interface.
rate shape
Shape the traffic output on the selected interface.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax rate shape [kbps] rate [ burst-KB ]
Parameters
kbps Enter the keyword
kbps
to specify the rate limit in Kilobits per
second (Kbps). On C-Series and S-Series, make the following value a
multiple of 64. The range is 0 to 10000000. The default granularity is
Megabits per second (Mbps).
rate Enter the outgoing rate in multiples of 10 Mbps. The range is 10 to
10000.
burst-KB (OPTIONAL) Enter the burst size in KB. The range is 0 to 10000. The
default is 10.
Defaults Granularity for rate is Mbps unless you use the
kbps
option.
Command Modes INTERFACE
1305