Dell Force10 S4810P, Reference Manual

Page: 237 / 1637

out Enter the keyword
out
to apply the ACL to outgoing traffic.
NOTE: Available only on the 12-port 1-Gigabit Ethernet FLEX line
card. For specifications, refer to your line card documentation.
Not available on the S-Series.
implicit-permit (OPTIONAL) Enter the keyword
implicit-permit
to change the
default action of the ACL from implicit-deny to implicit-permit (that is,
if the traffic does not match the filters in the ACL, the traffic is
permitted instead of dropped).
vlan
vlan-id
(OPTIONAL) Enter the keyword
vlan
followed by the ID numbers of
the VLANs. The range is 1 to 4094 and 1 to 2094 for ExaScale (you can
use IDs 1 to 4094).
Defaults Not enabled.
Command Modes INTERFACE
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Increased the name string to accept up to 140 characters. Prior to
7.8.1.0, names were up to 16 characters long.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1 Introduced on the E-Series.
Usage
Information You can assign one ACL (standard or extended ACL) to an interface.
NOTE: This command supports Loopback interfaces EE3 and EF series route processor
modules (RPMs). This command does not support Loopback interfaces ED series RPMs, C-
Series or S-Series Loopback interfaces.
When you apply an ACL that filters IGMP traffic, all IGMP traffic is redirected to the CPUs and
soft-forwarded, if required, in the following scenarios:
• on a Layer 2 interface - if a Layer 3 ACL is applied to the interface
• on a Layer 3 port or on a Layer 2/Layer 3 port
Related
Commands
ip access-list standard – configures a standard ACL.
ip access-list extended – configures an extended ACL.
ip control-plane egress-filter
Enable egress Layer 3 ACL lookup for IPv4 CPU traffic.
Z-Series, S4810
Syntax ip control-plane egress-filter
237