10-52
Handling, Diagnostic and Service Functions
MPH-02, MPB-02, MPD-02
DOK-INDRV*-MP*-02VRS**-FK01-EN-P
For input in
P-0-2003, Selection of functional packages
there presently
are the following possible combinations:
•
open-loop
without expansion packages
P-0-2003 = 0x0000 0001
•
open-loop
with
synchronization (SNC)
P-0-2003 = 0x0000 0021
•
open-loop
with
IndraMotion MLD-S (ML)
P-0-2003 = 0x0000 0
2
01
•
open-loop
with
synchroni IndraMotion MLD-S
P-0-2003 = 0x0000 0
2
21
•
closed-loop
without expansion packages
P-0-2003 = 0x0000 000
2
•
closed-loop
with
servo (SRV)
P-0-2003 = 0x0000 00
1
2
•
closed-loop
with
synchronization (SNC)
P-0-2003 = 0x0000 00
2
2
•
closed-loop
with
main spindle (MSP)
P-0-2003 = 0x0000 00
4
2
•
closed-loop
with
IndraMotion MLD-S (ML)
P-0-2003 = 0x0000 0
2
02
•
closed-loop
with
servo + IndraMotion MLD-S
P-0-2003 = 0x0000 0
2
12
•
closed-loop
with
synchroni IndraMotion MLD-S
P-0-2003 = 0x0000 0
2
22
•
closed-loop
with
main s IndraMotion MLD-S
P-0-2003 = 0x0000 0
2
42
Note:
Changes in parameter
P-0-2003, Selection of functional
packages
are only accepted by the drive after repeated
booting process.
Reducing the Active Functional Packages
The user can at any time reduce the scope of functions of the firmware by
deactivating individual functional packages. To do this, the functional
packages that are not required are reset (deactivated) in parameter
P-0-2003, Selection of functional packages
.
Subsequent Expansion (Additional Licensing)
The required functions are normally licensed by ordering the IndraDrive
firmware. At delivery, the licensed functions are indicated as firmware
type on the type plate of the control section and in addition internally
registered by Rexroth.
Note:
Bosch Rexroth can at any time prove which scope of functions
had been activated and thus licensed at delivery. If you use a
non-licensed function, any guarantee on the part of
Bosch Rexroth will expire!
In individual cases it is possible make an additional licensing, if you whish
to enable other functions than the ones contained in the ordered and paid
functionality. The procedure is described in the following section "Notes
on Commissioning".
Open-Loop Packages
Closed-Loop Packages
Courtesy
of
CMA/Flodyne/Hydradyne
▪
Motion
Control
▪
Hydraulic
▪
Pneumatic
▪
Electrical
▪
Mechanical
▪
(800)
426-5480
▪
www.cmafh.com
