Toshiba GR 200 Series, Инструкция по эксплуатации

Страница: 812 / 1563

6F2S1915 (0.46)
GRZ200 (Soft 031 & 032)
- 791 -
(iv)
Receiving “Select command P1-control” from the local-end.
Figure 4.9-8 outlines the reception of the select command ‘P1-control’ from the local-end.
Keying
“Select
command
”
P1 control from the local-end
Signal output
Select
decision
Success
Failed
Selection logic
P2controlfromthe remote-end
P3 control from the remote-end
P2 control from the local-end
P3 control from the local-end
P1 control by the PLC function
P2 control by the PLC function
P3 control by the PLC function
Select stage
Cancel logic
Wait for a command
Cancel command
Wait for a command
Operate logic
Operate command
Cancel logic
Operate logic
P1 control from the remote-end
Figure 4.9-8 Outline of select command ’P1-control’
Input signal generated at the local-end
Figure 4.9-9 shows the select logic when a “Select command (Local-P1-Control)” signal is
applied to the TPOS01 function. The signal is provided when a “Local-P1-control” key is
pressed on the IED front panel; the user is not required to map the signal from IEC61850. Note
that the user should set scheme switch [
TPOS01-CTRAHMI
] to
SBO
when the operation from
the IED front panel is required, we will discuss how to set in chapter
User interface: Control
sub-menu
.