Toshiba GR 200 Series, Инструкция по эксплуатации

Страница: 107 / 1563

6F2S1915 (0.46)
GRZ200 (Soft 031 & 032)
- 86 -
underreach setting in enough to the zone1
(S)
.
CTI
Busbar A
Busbar B
Zone1(S)
TZ1
X
Reach
U
R W
X
Line BJ
TZ2
S
TZ3
Busbar C
J
Line CJ
Line AJ
O
S
Zone2(S)
Zone3(S)
TZR1
Zone1(X)
Fault
Figure 2.1-58 Line CJ tapped at junction J
(iii)
Setting for the primary zone (Zone1 and a shot tapped line)
Suppose the busbar C is tapped at the junction J on the line AB, as shown in Figure 2.1-59. It
is required to have the reach setting in both the zone1(S) and the zone1(U) so as to hold a part
of the entire length of the line as shown in the long-dashed-short-dashed -circle line to avoid
unwanted operations for external faults at busbar C. Consequently, clearing faults by a delayed
zone2 are performed mostly, as shown in the broken-circle line that is operated at an end of
the line AB†.
Busbar A
Busbar B
Reach
U
Line AJ
S
Busbar C
J
Line JK
Line FJ
O
Busbar B Busbar A
Busbar C
U
S
O
broken-circle line
long-dashed-short-dashed-circle line
dotted-circle line
Figure 2.1-59 Short line CJ tapped at junction J
†Note: To solve the problem, we recommend using the distance carrier command
protection or the current differential protection for the multi-terminals line shown
in the dotted-circle line.