Toshiba GR 200 Series, Инструкция по эксплуатации

Страница: 861 / 1563

6F2S1915 (0.46)
GRZ200 (Soft 031 & 032)
- 840 -
Signal “TPOS01_PT_P1”
Signal “TPOS01_PT_P2”
Signal “TPOS01_PT_P3”
Signal “TPOS01_P3EX_BO”
OT5 OT6
Sensing intermediate state
P3
P3-control
P2
Intermediate
a. Switch motion (P2 to P3) b. Operate command and signals with regard to the switch motion (P2 to P3)
Intermediate
P1
Figure 4.9-53 Two intervals (OP7 and OP8) for P3 control
Table 4.9-27 Eight intervals measured in TPOS01 function
Intervals Trigger Events for measurement
OT1
Start Signal “TPOS01_P2EX_BO” sensed
End Signal “TPOS01_PT_P1” unsensed
OT2
Start Signal “TPOS01_PT_P1” sensed
End Signal “TPOS01_PT_P2” unsensed
OT3
Start Signal “TPOS01_P1EX_BO” sensed
End Signal “TPOS01_PT_P2” unsensed
OT4
Start Signal “TPOS01_PT_P2” is sensed
End Signal “TPOS01_PT_P1” unsensed
OT5
Start Signal “TPOS01_P2EX_BO” sensed
End Signal “TPOS01_PT_P3” unsensed
OT6
Start Signal “TPOS01_PT_P3” sensed
End Signal “TPOS01_PT_P2” unsensed
OT7
Start Signal “TPOS01_P3EX_BO” sensed
End Signal “TPOS01_PT_P2” unsensed
OT8
Start Signal “TPOS01_PT_P2” sensed
End Signal “TPOS01_PT_P3” unsensed
†Note: The function “operation time measurement” is also available in the TPOS02 and
TPOS03 functions.
The user can clear the operation-intervals (OT1 to OT8) by key-operation of the
“Operation time” sub-menu or operation from the remote-end. Figure 4.9-54 shows that the
user can clear the eight operation times using this screen. See chapter
User interface:
Monitoring sub-menu
for the operation.