Toshiba GR 200 Series, Инструкция по эксплуатации

Страница: 536 / 1563

6F2S1915 (0.46)
GRZ200 (Soft 031 & 032)
- 515 -
(iii)
Cancel condition logic
Figure 4.1-18 shows the cancel condition logic. As the criteria, “unmatched condition detected”
is connected normally for the cancel logic, set
Fixlogic
for the scheme switch
[
SPOS01_LGCNFFC
].
SPOS01 function (Function ID: 510001)
User configurable condition (PLC connection point)
Fixedlogic
[ SPOS01-LGSLFFCT ]
To cancel logic in
SPOS01
Unmatched condition detected *1
SPOS01IN_TMP_46 510001 800101EE69
&
&
1
≥
Figure 4.1-18 Logic “Cancel condition” in SPOS01
1
Note: The Criteria “unmatched conditions” are determined when the “Test-bit status” in
the cancel command is not identical to the “IED test status”, like in Figure 4.1-13.
2
Note: With the exception of the above ‘cancel’ condition logic, there is an operate-
condition logic within the SPOS01 function; the operate-condition logic will always
checks conditions. That is, the user is required to set either the “operate-
condition” or the “cancel-condition” logic.
If the original logic does not meet with the requirements of the user, it can be replaced
with another logic using the connection point “User Configurable condition”:
1. Connect the user-customized logic with the “SPOS01IN_TMP_46”.
2. Set scheme switch [
SPOS01-LGCNFFCT
] to
PLC
.
(iv)
Signal name and number
Note: The user should note the following descriptions shown in the column “M/O” in
each table:
“O” indicates that the signal is provided for optional use.
“M” indicates that the user should map/set/configure using the signal;
otherwise, the user may experience an operational failure for the default
settings.
“N/A” indicates that the user cannot change the state of the signal.
Table 4.1-11 PLC connection points (Input signal for ‘cancel’ condition)
Signal Number Signal Name Description M/O
510001 800101EE69 SPOS01IN_TMP_46 SPOS01 user configurable cancel condition O
510001 800102EE69 SPOS02IN_TMP_46 SPOS02 user configurable cancel condition O
510001 800103EE69 SPOS03IN_TMP_46 SPOS03 user configurable cancel condition O
… … …
510001 800114EE69 SPOS20IN_TMP_46 SPOS20 user configurable cancel condition O
Table 4.1-12 PLC monitoring points (Output signal for ‘cancel’ condition)
Signal Number Signal Name Description
510001 8601011E95 SPOS01_CC_SS Cancel succeed in SPOS01