Rohde & Schwarz R&S FSP Series, Руководство по эксплуатации

Страница: 643 / 796

Operating Manual 1164.4556.12 - 06 6.249
R&S FSP Remote Control – Description of Commands
TRIGger Subsystem
TRIGger<1|2>[:SEQuence]:LEVel:RFPower -50 to –10 dBm
This command sets the level of the RF power trigger source.
Example:
"TRIG:LEV:RFP –20DBM"
Characteristics: *RST value: -20 dBm
SCPI: device-specific
Mode: A
This command is only available with option R&S FSP-B6 (TV and RF Trigger).
TRIGger<1|2>[:SEQuence]:LEVel:VIDeo 0 to 100PCT
This command sets the level of the video trigger source.
Example:
"TRIG:LEV:VID 50PCT"
Characteristics: *RST value: 50 PCT
SCPI: device-specific
Mode: A
TRIGger<1|2>[:SEQuence]:SLOPe POSitive | NEGative
This command selects the slope of the trigger signal. The measurement starts on a positive or negative
slope of the trigger signal. The selected trigger slope applies to all trigger signal sources.
Example:
"TRIG:SLOP NEG"
Characteristics: *RST value: POSitive
SCPI: conform
Characteristics: SCPI: device-specific
Mode: A
TRIGger<1|2>[:SEQuence]:SOURce IMMediate | EXTernal | VIDeo | IFPower | RFPower | TV
This command selects the trigger source for the start of a sweep.
Parameter:
The trigger source selection has to be done with the command
TRIGger<1|2>[:
SEQuence]:SYNChronize:ADJust
.
The selection RFPower or TV is only available with option R&S FSP-B6 (TV and
RF Trigger).
The selection of trigger sources is extended by option FM Demodulator (R&S FS-
K7) (see manual for option).
IMMediate Automatic triggering of the next measurement at the end of the
previous one. The value IMMediate)corresponds to the FREE RUN
setting.
EXTernal The next measurement is triggered by the signal at the external
trigger input.
VIDeo The next measurement is triggered by the detection of a signal at
the video filter output.