Rohde & Schwarz R&S FSP Series, Руководство по эксплуатации

Страница: 579 / 796

Operating Manual 1164.4556.12 - 06 6.185
R&S FSP Remote Control – Description of Commands
SENSe Subsystem
1. Setting up the instrument and at the same time querying the result list:
This method ensures the smallest delay between measurement and the output of the measured
values, but requires the control computer to wait actively for the response of the instrument.
2. Setting up the instrument and querying the result list after synchronization to the end of measurement:
With this method the control computer can be used for other activities while the instrument is
performing the measurement at the cost of additional time needed for synchronization via service
request.
[SENSe<1|2>:]MPOWer:RESult[:LIST]?
This command queries the results of a multiple burst power measurement as configured and initiated
with
SENSe:MPOWer[:SEQuence]
. The results are output in a comma-separated list of floating point
values. The unit used for the return values is always dBm.
This command may be used to obtain measurement results in an asynchronous way using the service
request mechanism for synchronization with the end of the measurement.
If no measurement results are available, the command will return a query error.
Example:
*ESE 1
*SRE 32
'Configuration of status reporting systems for the generation of an SRQ on
operation complete
SENSe:MPOWer
935.2MHz,1MHz,434us,VIDEO,50PCT,5us,MEAN,20;*OPC
'Configuring and starting the measurement
...
'Further actions of the control computer during measurement
On SRQ:
'Response to service request
SENSe:MPOWer:RESult?
Characteristics: *RST value: --
SCPI: instrument-specific
Mode: A-F, A-T