Rohde & Schwarz R&S FSP Series, Руководство по эксплуатации

Страница: 498 / 796

R&S FSP Remote Control – Description of Commands
DIAGnostic Subsystem
6.104 Operating Manual 1164.4556.12 - 06
DIAGnostic<1|2>:SERVice:INPut[:SELect] CALibration | RF
This command toggles between the RF input on the front panel and the internal 128 MHz reference
signal in the selected measurement window. The level of the 128-MHz signals can be selected by
DIAGnostic<1|2>:SERVice:CSOource[:POWer] command.
Example:
"DIAG:SERV:INP CAL"
’ Selects the internal reference signal.
Characteristics: *RST value: RF
SCPI: device-specific
Mode: A
DIAGnostic<1|2>:SERVice:NSOurce ON | OFF
This command switches the 28 V supply of the noise source at the rear panel on or off.
The numeric suffix <1|2> is ignored with this command.
Example:
"DIAG:SERV:NSO ON"
Characteristics: *RST value: OFF
SCPI: device-specific
Mode: A
DIAGnostic<1|2>:SERVice:SFUNction ’<string>’
This command activates a service function which can be selected by indicating the five parameters:
function group number, board number, function number, parameter 1 and parameter 2 (see service
manual). The contents of the parameter string is identical to the code to be entered in the data entry
field of manual operation.
The entry of a service function is accepted only if the system password Level 1 or Level 2 has been
entered previously (command:
SYSTem:SECurity
).
The numeric suffix <1|2> is ignored with this command.
Example:
"DIAG:SERV:SFUN '2.0.2.12.1'"
Characteristics: *RST value: -
SCPI: device-specific
Mode: A
The service functions of the instrument are not identical to those of the FSE family.
That is why the remote command differs in syntax and data format.