Rohde & Schwarz R&S FSP Series, Руководство по эксплуатации

Страница: 497 / 796

Operating Manual 1164.4556.12 - 06 6.103
R&S FSP Remote Control – Description of Commands
DIAGnostic Subsystem
DIAGnostic<1|2>:SERVice:INPut:PULSed[:STATe] ON | OFF
This command toggles the calibration signal in the selected measurement window between pulsed and
non-pulsed.
The selection takes effect only if the RF input has been set to the internal reference signal using the
DIAGnostic<1|2>:SERVice:INPut[:SELect] command.
Example:
"DIAG:SERV:INP CAL"
"DIAG:SERV:INP:PULS ON"
Characteristics: *RST value: OFF
SCPI: device-specific
Mode: A
This command is only available in conjunction with the optional Broadband Calibration Source
R&S FSP-B15.
DIAGnostic<1|2>:SERVice:INPut:RECTangle:PRATe <numeric_value>
This command sets the frequency of the rectangle calibration signal in the selected measurement
window (suffix <1|2>).
Only 5 kHz can be set.
Example:
"DIAG:SERV:INP:RECT:PRAT 128 MHz"
Characteristics: *RST value: 5 kHz (with option R&S FSP-B15)
SCPI: device-specific
Mode: A
This command is only available for the model R&S FSP 40 or with the option R&S FSP-B15.
DIAGnostic<1|2>:SERVice:INPut:RECTangle[:STATe] ON | OFF
This command switches the rectangle calibration signal on or off in the selected measurement window
(suffix <1|2>). The setting takes effect only if the RF input is set to the internal reference signal (
DIAG:
SERV:INP CAL
command).
Example:
"DIAG:SERV:INP CAL"
"DIAG:SERV:INP:RECT ON"
Characteristics: *RST value: OFF
SCPI: device-specific
Mode: A
This command is only available with the option R&S FSP-B15.
If the rectangle calibration signal is switched on, the pulsed calibration signal is
switched off.