Rohde & Schwarz FSW13, Руководство пользователя

Страница: 586 / 1150

General Instrument Setup
R&S
®
FSW
586 User Manual 1173.9411.02 ─ 19
9.3.5.3 Calibration Signal Display
Alternatively to the RF input signal from the front panel connector you can use the
instrument's calibration signal as the input signal, for example to perform service func-
tions on.
The calibration signal settings are available in the "Calibration Signal" tab of the "Ser-
vice" dialog box.
None ............................................................................................................................586
Calibration Frequency RF ........................................................................................... 587
└ Spectrum .......................................................................................................587
└ Frequency ..................................................................................................... 587
Calibration Frequency MW ..........................................................................................587
Calibration Analog Baseband ......................................................................................587
└ Calibration Signal Type .................................................................................587
None
Uses the current RF signal at the input, i.e. no calibration signal (default).
Remote command:
DIAGnostic:
​
SERVice:
​
INPut[:
​
SELect]
​
on page 1024
General Instrument Settings