Mitsubishi Electric MELSEC iQ-R RD75P4, Руководство пользователя

Страница: 434 / 598

432
12 DATA USED FOR POSITIONING CONTROL
12.4 Positioning Data
[Da.10] M code
Set M code, Number of pitch, Condition data No., or Number of LOOP to LEND repetitions depending on how [Da.2] Control
method is set.
• If a method other than JUMP instruction and LOOP is selected as the setting value in [Da.2] Control method, set M code. If
M code does not need to be output, set 0 (default value).
• If 3-axis helical interpolation control is selected as the setting value in [Da.2] Control method, set the number of pitch for the
linear interpolation axis. The rotation speed of the circular interpolation is set with the number of pitch.
• If JUMP instruction is selected as the setting value in [Da.2] Control method, set Condition data No. for JUMP. When 0 is
set, an unconditional JUMP is performed to the positioning data specified by the value set in [Da.9] Dwell time. When 1 to
10 is set, JUMP is performed according to the condition data No. specified (a number between 1 and 10).
• If LOOP is selected as the setting value in [Da.2] Control method, set the number of LOOP to LEND repetitions. If 0 is set,
Control method LOOP setting error (Error code: 1A33H) occurs.
■
Buffer memory address
For the buffer memory address of this area, refer to the following.

Page 551 Positioning data
■
Setting range
The setting range depends on the setting of [Da.2] Control method.
■
Default value
The default value is 0 for all the axes.
[Da.27] M code ON signal output timing
Set the M code ON signal output timing for each positioning data.
For details on the settings, refer to the following.
 Page 395 [Pr.18] M code ON signal output timing
■ Configuration of positioning option
The positioning option consists of [Da.27] M code ON signal output timing to [Da.29] Interpolation speed specification method.
These three setting values are stored in a buffer memory address. Set the values in [Da.27] M code ON signal output timing to
[Da.29] Interpolation speed specification method according to the configuration of positioning option shown in the following
figure.
■
Buffer memory address
For the buffer memory address of this area, refer to the following.

Page 551 Positioning data
■
Default value
The default value is 0: Use the setting value in [Pr.18] M code ON signal output timing for all the axes.
Setting of [Da.2] Control method Setting value Setting detail
JUMP instruction: 82H 0 to 10 Condition data No.
LOOP: 83H 1 to 65535 Number of repetitions
Helical interpolation: 20H to 25H 0 to 999 Number of pitch
Other than the above 0 to 65535 M code
M code ON signal output timing Setting value
Use the setting value in [Pr.18] M code ON signal output timing 0
WITH mode 1
AFTER mode 2
Configuration of positioning option Assignment
(1) [Da.27] M code ON signal output timing
(2) [Da.28] ABS direction in degrees
(3) [Da.29] Interpolation speed specification method
(4) Use prohibited (fixed to 0)
b15 b14 b13 b12 b11 b10 b9 b8 b7 b6 b5 b0 b1 b2 b3 b4
(4) (3) (2) (1)