GE CARESCAPE, Руководство пользователя

Страница: 259 / 548

Temperature
Stopping the temperature measurement
1. Select the temperature parameter window.
2. Select Measurement > Off .
Temperature practicalities
●
Each temperature label can be changed to reflect the temperature measurement
site.
●
Individual temperature sites can be turned off.
●
Tblood is obtained from a pulmonary artery catheter.
●
The difference between two temperature sites can be calculated and displayed.
●
The dual temperature cable allows a two-channel measurement. The temperature
cable switch can be set to 400 or 700 depending on the type of probe used. Since
only 400 is supported, make sure that you turn the switch to this position.
●
The signal input is a high-insulation port to ensure patient safety and to protect the
device during defibrillation and electrosurgery.
●
The monitor automatically calibrates the temperature measurements at startup:
every 10 minutes for PSM, and every minute for PDM and TRAM.
Temperature troubleshooting
Problem Solution
Temperature measurement fails
●
Check that the probe adapter is properly
connected to the acquisition module.
●
Check that the probe is properly connected to the
probe adapter.
●
Check that you are using the correct probe for the
anatomical location being monitored
●
Use a probe that is compatible with your system.
●
Try using a known good probe in case the sensor
is damaged.
●
Check that the acquisition module is properly
connected to the monitor.
●
Check the patient connection.
●
Check that there are not two identical
measurement modules in the system.
●
Contact service if the problem continues.
2062971-001 CARESCAPE Modular Monitors 259