GE CARESCAPE, Руководство пользователя

Страница: 241 / 548

Invasive pressures
1. Select the invasive pressure parameter window.
2. Select the Setup tab.
3. Select Optimize Scale .
The Scale selection will now show the automatic limit range.
NOTE
The Optimize Scale selection will not automatically change
to match the waveform, you will always have to select it
manually every time.
Selecting the hemodynamic waveform sweep speed
NOTE
This setting adjusts the waveform speed for all of the
hemodynamic parameters.
1. Select the invasive pressure parameter window.
2. Select the Setup tab.
3. Select a numeric value from the Hemodynamic Sweep Speed list.
The smaller the value, the slower the sweep speed.
Selecting the invasive pressure noise reduction filter
NOTE
If arterial pressure is used to trigger the intra-aortic balloon
pump, use the 40 Hz pressure filter.
1. Select the invasive pressure parameter window.
2. Select the Setup tab.
3. Select a numeric value from the Filter Hz list.
The smaller the filter value, the greater the degree of filtering that occurs.
Selecting the displayed invasive pressure format
You can choose to display systolic, diastolic or mean pressure values in different
formats.
1. Select the invasive pressure parameter window.
2. Select the Setup tab.
3. Select the format from the Parameter Format list:
●
Mean only : Only the mean value is shown.
●
Sys/Dia (Mean) : All values are shown, but the sys/dia values are shown in a
bigger font.
●
(Mean) Sys/Dia : All values are shown, but the mean value is shown in a bigger
font.
●
Sys/Dia /Mean : All values are shown in an equally big font.
Selecting invasive pressure as the primary heart rate source
The primary heart rate can be calculated from the ECG leads, SpO
2
measurement,
or invasive pressure waveform.
2062971-001 CARESCAPE Modular Monitors 241