GE CARESCAPE, Руководство пользователя

Страница: 311 / 548

CO2 with CAPNOSTAT Mainstream, CapnoFlex LF, and Dual CO2 modules
4. Place the sensor on the cell marked 0 and select Start Zeroing .
5. After the message Zeroed appears, remove the sensor from the 0 cell and attach
it to the cell marked REF .
The measured EtCO
2
value appears in the Connect sensor to REF cell window. If
the value stays between 36 and 40 mmHg for three seconds during the 20-second
calibration, the calibration is successful and the message
Calibrated appears. If the
calibration fails, the message Recalibrate appears instead. In this case, perform
a new calibration.
Calibrating the CAPNOSTAT Mainstream adapter
Adapter calibration should be performed whenever the message Check/calibr.
adapter appears.
1. Place the sensor and adapter away from all sources of CO
2
, including the patient’s
exhaled breath, your exhaled breath, and ventilator exhaust valves.
2. With the adapter connected to the sensor and the sensor connected to the
monitor (and, when used, all sidestream tubing attached and the pump turned
on), select the gases parameter window.
3. Select the Calibration tab.
4. Select Start Calibrating .
The message Calibrated appears on the screen after a successful calibration. If the
calibration fails, the message Calibration error appears instead. In this case, perform
a new calibration.
Equipment connection with CapnoFlex LF module
For intubated and non-intubated patients.
1. CAPNOSTAT Mainstream or Dual CO2 module
2. Adapter cable
2062971-001 CARESCAPE Modular Monitors 311