Cooper Security i-On 40, Инструкция по эксплуатации

Страница: 102 / 228

Installer Menu Options i-on Range
Page 92
Enabled The user must first trigger an entry zone and start the entry
timer before unsetting the system with a remote control.
Disabled The user can unset the system using a remote control without
first starting the entry timer.
HUA Response
Note: In a part setting system the HUA Response option appears in the System
Options menu. In a partitioned system, each partition can have its own
HUA response, and therefore each partition menu has a HUA Response
menu option. In both cases the HUA Response menu option offers the
same choices. See page 74 for a description of these choices.
Auto Rearm
(Appears when
System Options – Confirmation Mode
is set to ―Basic‖, see page
83.)
To change the number of times that the system will re-arm when the siren
time expires select:
System Options
-
Auto Rearm
.
Select NEVER to make the system never re-arm (the system will go into alarm
once only). Select one of the other options to make the system re-arm once,
twice, three, four or five times, or always. The system re-arms all closed
zones, but not detectors that are still sending alarm signals. (
Note that this
setting is required in order to comply with EN50131. )
If the system has rearmed, then when a user enters the system through the
Final Exit door the control unit will give an audible internal alarm in place of
the normal entry tone.
Panel Loudspeaker
Loudspeaker 1 (or 2)
This option allows you to control the volume and the partition assignment of
each of the loudspeaker(s) connected directly to the control unit.
Volume
Use this option to change the volume of notification tones from loudspeakers
connected to loudspeaker terminals 1 on the control unit (on an i-on160EX you
can also change the volume of loudspeaker 2). Press

to lower the volume or

to raise the volume. The display shows the current volume setting by a row
of stars (for example ―****‖). This volume control does NOT change the
volume of alarm tones.
Partitions
In a partitioned system you can assign the panel loudspeakers to any of the
partitions. Any loudspeaker can belong to one or more partitions.
Once you have entered the Partitions option, press

or

to scroll through
the list of partitions followed by

or

to allocate/deallocate the loudspeaker
to each partition as necessary.
If you wish to allocate/deallocate the loudspeaker to many partitions you can
use the ―All Partitions‖ option (in between the first and last partition on the
menu) to either allocate or deallocate the loudspeaker to all partitions in one