Cooper Security i-On 40, Инструкция по эксплуатации

Страница: 118 / 228

Installer Menu Options i-on Range
Page 108
Figure 10. Speech Dialler Programming.
If the control unit has Call Acknowledge enabled (see page 110), then the
person receiving the speech messages can control the link by sending DTMF
tones back to the control unit (usually by pressing buttons on the telephone
key pad). The commands available are:
Function Key
End this call DTMF ‗5‘
Play ‗Home‘ and ‗alarm‘ message DTMF ‗3‘
Clear down DTMF ‗9‘
Note that when the called party answers a speech dialler call there could be a
six second delay before the control unit starts playing the home message.
Call Mode
This option enables or disables the speech dialler feature. To employ speech
dialling set the call mode to ―Enabled‖.
Messages
To record the speech messages you wish the speech dialler to use enter
Installer Menu and select
Communications – Speech Dialler – Messages
.
There are five messages slots available: The Home Message and Messages 1 to
4. The i-sd01, i-sd02 and i-gsm02 can record up to ten seconds of speech for
the Home message, and up to five seconds of speech for each of the alarm
messages. Within each message you can use one of the following options:
Record Message Press

to start recording. The control unit starts recording
from the i-sd02 or i-gms02‘s built in microphone. The
display shows a progress bar indicating how long you
have left to record. Press

to end recording.
Play Message Press

to play back the message from the i-sd02 or i-
gsm02‘s speaker.
None
Fire Alarm
Panic Alarm
Burglar Alarm
Technical Alarm
Mains Fail
Home message
Dest 1 Y
Dest 2 N
Dest 3 Y
Dest 4 N Message 1
Dest 1 N
Dest 2 N
Dest 3 N
Dest 4 N Message 2
Dest 1 N
Dest 2 N
Dest 3 N
Dest 4 N Message 3
Dest 1 N
Dest 2 Y
Dest 3 N
Dest 4 Y
Message 4
Dest 1 = Tel No: 1234567 8
Dest 2 = Tel No: 8765432 1
Dest 3 = Tel No: 5678123 4
Dest 4 = Tel No: 2143658 7
Report Triggers Messages Destinations Phone Book
Tampers
Soak Test Fail