Cooper Security i-On 40, Инструкция по эксплуатации

Страница: 146 / 228

Step by Step Programming Procedures i-on Range
Page 136
10. Press

until the display shows:


11. Press

.
The display shows:


After a short time (depending on the number of
bus devices fitted to the system) the display
shows the time and date, for example: 

The keypad navigation key LEDs will glow red
with an alert. When a user reads the alert it will
show the address of the disabled expander.
If you change your mind and wish to enable the
expander again after you have left the Installer
menu, then repeat steps 1 to 11, but at step 8
press

or

until the end of the bottom line
shows ―Yes‖.
To Replace an Expander:
1. Enter Installer Menu.


2. Press

.
The display shows:


3. Press

until the display shows:
EITHER (if you are replacing a wired expander):
OR (if you are replacing a radio expander):




(The rest of these instructions assume you are
replacing a wired expander. The instructions are
similar but the displays are slightly different for
a radio expander.)
4. Press

.
The display shows:


5. Press

until the display shows:


6. Press

.
The display shows the first in a list of the
expanders that are currently connected to the
bus.

