i-on Range
Appendix III
Page 203
Deleting Devices
If you need to delete detectors from a WAM, perhaps in order to move them
from one repeater to another, then:
1. Enter programming mode as follows:
a) Open the tamper switch.
The Red Trouble LED glows.
b). Press SELECT.
The blue LED 1 glows.
2. Press SELECT.
The blue LED 2 glows.
3. Press SET.
The WAM is in menu 2 – Delete Detectors.
If any blue LEDs flash then those channels are in
use.
4. If necessary, press SELECT to select the detector
you wish to delete. The blue LED of the selected
detector flashes.
5. Press and hold ESC for at least four seconds.
The WAM sounder gives a double beep to confirm
that the WAM has deleted the transmitter from
that channel. The blue LEDs show menu 2.
6. Repeat steps 3 to 5 for the other detectors as
necessary.
7. Leave programming mode as follows:
a) Leave menu 2 by pressing ESC. The sounder
gives a regular beeping tone to remind you to
replace the lid.
b) Close the lid tamper.
After a few seconds the WAM bleeps twice and
the red Trouble LED goes dark.
NOTE: You must leave programming mode in order to
save the changes you have made.
4s
Содержание i-On 40
Страница 1: ......
Страница 10: ...i on Range Page x This page is intentionally blank...