Cooper Security i-On 40, Инструкция по эксплуатации

Страница: 119 / 228

i-on Range Installer Menu Options
Page 109
Delete Message Press

to delete the message. When the display asks
―Delete Message?‖ press

.
Use Lid Tamper This puts the control unit into a special mode where the
tamper switch controls the recording and playback of
the current message. Use this mode if the control unit
is an inconvenient distance from the keypad.
1. Start with the control unit lid off and the tamper switch open.
2. At the keypad select
Use Lid Tamper
and press

.
3. At the control unit hold down the tamper switch. When the red LED on the
i-sd02 or i-gsm02 glows recite your message.
4. Release the tamper switch.
5. Pulse the tamper switch briefly.
The i-sd02 or i-gsm02 plays back your recording.
6. Go back to the keypad and press

.
7. If required, replace the control unit lid. DO NOT replace the control unit
lid until you have left the ―Use Lid Tamper‖ mode.
Phone Book
To record the telephone numbers that you wish to use, select
Communications –
Speech Dialler – Phone Book
. (See ―Destinations‖ on page 110 for instructions
how to link messages to phone numbers.)
Select one of the telephone numbers.
The display shows the current digits of the selected telephone number.
Key in the telephone number. Press * to add a two second pause, if required.
The display shows this as a comma.
Press

when you are happy that the number is correct.
The display then gives you a chance to key in a name for that number. The
control unit will display this name in the phone book to help you remember
what destination you wanted the message to go to. (See page 18 for hints on
editing text.) Press

when you are happy that the name is correct.
Note that once you have set the speech dialler call mode to ―enabled‖ (see
page 108) and assigned a report trigger a message, and a message to a
telephone number (see below) then the control unit makes this number
available in the User Menu. User 01 can enter a new telephone number in this
slot at will. This allows the user to re-direct any speech message destined for
this number. The user cannot disable the telephone number by entering a
blank number; the fact that they have changed the number is logged.
Triggers
In the control unit you can link up to five different trigger events to each
speech message. A trigger event is one item selected from a list of alarm
types.
To link specific trigger events to individual messages select
Communications –
Speech Dialler – Triggers
.