Cooper Security i-On 40, Инструкция по эксплуатации

Страница: 139 / 228

i-on Range Installer Menu Options
Page 129
Comms
The contents of this option depend on the plug-on communications module
fitted to the control unit. When no module is present the Panel Ethernet option
is the only one visible. (For the i-on30EXD this option also shows the state of
the built-in communicator.)
Module: Shows the identity of the communications module currently fitted.
Panel Ethernet 40 50 160 shows information about Internet Protocol
(IP) settings used by the control unit itself. You will need this information when
you set up an Ethernet connection from a PC to the control unit in order to use
the built in web browser interface. To change the settings use the
Communications – IP Network (Own)
menu (see page 114).
IP Address This is the IP address the control unit uses when linked by
Ethernet to a PC.
Subnet Mask This is the subnet mask currently in use by the control unit
itself.
Gateway Address This is the gateway address being used by the control unit.
MAC Address
This is the unique MAC address of the control unit PCB.
Each control unit PCB will have an individual MAC address.
IP Link Status This option shows the current status of the Ethernet link
between a PC and the control unit. The display shows ―Fail‖
when there is no link, and ―OK‖ when the Ethernet link is
established. Note that ―OK‖ only shows that the link is
established, it does not show that the PC is logged into the
control unit.
Zone Mapping
30 50 160
This option allows you to check which zones are currently allocated to detector
connection points, or which detector connection points have zone numbers
allocated. There are two options:
Zone Number
The display shows a list of zone numbers (with names), with detector
connection points for each zone.
Zone address
The display shows a list of detector connection points, with zone numbers
and names, where allocated.