Cooper Security i-On 40, Инструкция по эксплуатации

Страница: 209 / 228

i-on Range Appendix III
Page 199
3. Set the WAM to the Mode 1 (Repeater)
1. Apply power to the WAM.
2. Enter programming mode as follows:
a) Make sure the tamper switch has opened.
The Red Trouble LED glows.
b). Press SELECT.
The blue LED 1 glows. The WAM is in menu 1.
3. Use menu 7 to go into mode selection as follows:
a) Press SELECT repeatedly until LED 7 glows.
b) Press SET.
The blue LEDs show the current mode. When
delivered from the factory the WAM is in mode 1
(LED 1 glowing).
4. If necessary, select mode 1 by pressing SELECT
repeatedly until LED 1 lights up.
(Note that LED 6 does not light up.)
5. Press SET.
The sounder gives a double ―beep‖ and the LED
7 glows again. The WAM is now back in menu 7.
6. Leave programming mode as follows:
a) Press ESC/DEL.
The blue LED goes dark. The sounder gives a
regular beeping tone to remind you to replace
the lid.
b) Replace the lid (or operate the tamper switch).
After a few seconds the red Trouble LED switches
off and the sounder gives a double beep
confirmation tone.
NOTE: You must leave programming mode in order to
save the changes you have made.
xn