Cooper Security i-On 40, Инструкция по эксплуатации

Страница: 25 / 228

i-on Range Basic Programming Procedures
Page 15
16 i-on16 loads defaults at this point. Go
to step 15.
30 40 50 160The display asks you to
select Partition Mode or Part Set Mode. (See
page 6.)


11. EITHER: Press A to create a partition based
system.
OR Press B to create a part setting system.
30 40 : The i-on30EX, i-on40 control
units are Grade 2 only and do not show this
display. Go to step 13.
50 160 The display asks you to select the
Security Grade. (See page 6.) Go to step 12.


12. 50 160 Press

or

to select either
Security Grade 3 or Security Grade 2 settings.
Note: If you change Grades then the keypad display
reminds you that all user codes will be
defaulted.
(If you change your mind at this point and do
not wish to default user codes then press

to
stay with the current security grade.)
50 160 Press

to confirm your selection.
The display asks you to select the zone wiring
type. (See page 80.)


13. Press

or

to select the desired wiring type
on the bottom line of the display.


14. Press

to confirm the selection.
The system loads all defaults except for the
Log.
Note: The log is protected and cannot be erased by
the Installer or Master User.
The display briefly shows:


Followed by:


15. Press

until the display shows:

