Cooper Security i-On 40, Инструкция по эксплуатации

Страница: 215 / 228

i-on Range Appendix IV
Page 205
6. Press Select until the display shows ―n6‖, the Output Module
Mode:
n6
7. Press Set.
The display shows the Output Mode command ―OP‖ again:
OP 
8. Press Set.
The display shows the first channel number:
C1 
9. Press Select until the display shows the next channel that you
want to set to output mode, for example:
C2 
10. Press Set.
The display shows the channel‘s current mode, for example:
n1 
11. Press Select until the display shows ―n6‖, the Output Module
Mode:
n6 
12. Press Set.
The display shows the Output Mode command ―OP‖ again.
OP 
13. On a 768r/769r repeat steps 8 to 12 for all the other channels
that you want to use as outputs.

Disable Infra-red learning
Enter programming mode if the 762r or 768r/769r is not
already there.
Ln
14. Press Select until the display shows the Infra Red Learn
command ―IR‖:
Ir
15. Press Set.
The display shows
E
if infra read learning is enabled, or
d
if
infra red learning is disabled (radio learning enabled).
E
16. Press Select until the display shows ―disable‖.
d
17. Press Set.
Ir
NOTE: If you disable infra-red learn then the receiver enables radio learn. If
you enable infra-red learn then the receiver disables radio learn.
Set to manual learn
18. Press Select until the display shows the manual learn
command ―Ln‖.
Ln
19. Press Set.
The display shows the first available channel number, for
example ―C1‖:
C1