Cooper Security i-On 40, Инструкция по эксплуатации

Страница: 77 / 228

i-on Range Installer Menu Options
Page 67
Type:
(nn=shortcut) Active when: Assign to
Partitions?
Zone Follow
(39)
30 40 50
160
A specified zone has been triggered. When
you select this type for a zone the display
shows an extra ―Follow‖ option for the
output. Use this option to select the zone
you wish the output to follow. (You can
also follow a ―Log Only‖ zone.)
No
Zone Alarm (40)
30 40 50
160
The selected zone causes an alarm.
Deactivated when the alarm has been
reset. When programming this output type
the installer can select a specific zone for
the output to follow.
No
Masking (41)
30 40 50
160
The control unit operates this output
whenever a detector is giving a ―mask‖
signal (see page 87).
No
Autoset Warning
(42)
50 160
The control unit starts the Calendar Set
Warning period (see page 79). Deactivates
when the system sets, or if a user defers
or cancels the calendar set.
Yes (all
partitions by
default)
User Defined
(43)
The user switches the output on or off from
the keypad, or a remote control. Assign
this output type to any outputs that you
want the user to control.
Note: You cannot assign this output type to
a control unit plug-by-output.
See ―Programming User Defined Outputs‖
on page 68 for more details.
Yes
Line Fault (44) The control unit detects a communications
fault. Deactivates when the
communications fault clears
No
Courtesy Light
(45)
The entry or exit timer is running. The
control unit activates this output when the
entry or exit time starts, and deactivates
the output 10 seconds after the entry or
exit time stops.
Installer On Site
(46) The control unit is in Installer Menu. The
control unit activates the output when it
enters Installer Menu, and deactivates the
output once it has successfully left Installer
Menu.
Duress Code
(47) A Duress code has been used. The control
unit activates this output whenever a user
keys in a Duress code, and deactivates the
output when a user or engineer resets the
system.