Cooper Security i-On 40, Инструкция по эксплуатации

Страница: 135 / 228

i-on Range Installer Menu Options
Page 125
User Hold Up Alarms
The Test menu allows you to test user‘s HUA transmitters. You must have the
HUA transmitter to carry out the test. From the Installer Menu select
Test –
User Hold Up Alarms
.
The keypad display shows a message asking you to press the HUA buttons.
Press the HUA buttons, both at the same time. (The alarm system will not start
a HUA alarm as a result.)
The keypad display shows the HUA‘s owner. The bottom line of the display
shows the signal strength.
Note: To test wired HUA buttons use the
Test – Walk Test
option. To test HUA
buttons on a keypad, use the
Test – Wired Keypad
option. If you attempt to
test either of these functions while in User Hold Up Alarms you will start a
genuine HUA.)
Prox Tags
The Test menu allows you to test a user‘s proximity tag. (You must have the
proximity tag in order to test it.) From the Installer Menu select
Test – Prox Tag
.
The keypad display shows a message asking you to present the tag to the
keypad.
Hold the prox tag up to the keypad.
The keypad display shows the owner of the prox tag.
ARC Reporting
(For the i-on40, i-on30EX and i-on160EX this option appears only when the i-
sd02, i-dig02 or i-gsm02 module is fitted. For the i-on30EXD this option is
always available. For the i-on16 this option appears only when the i-sd01 is
fitted.)
The Test menu allows you to send a test call to either of the two telephone
numbers you have programmed to receive alarm information. The control unit
must have a suitable communications module fitted. ARC reporting must be
enabled (see page 99 ).
From the Installer Menu select
Test – ARC Reporting – Tel No 01
(or
Tel No 02
).
If the control unit uses SIA or CID reporting then the control unit starts the
test call as soon as you press

. Press

to abandon the test call.
If the control unit uses Fast Format reporting then when you press

the
keypad display shows you the first in a list of the available Fast Format
channels. Press

or

to scroll up or down the list. Press

or

to select a
channel for testing. Press

to start the test call.
During the test call the keypad display will show a sequence of progress
messages.
If the call fails the keypad display will show a brief message giving the reason
for failure.