Cooper Security i-On 40, Инструкция по эксплуатации

Страница: 60 / 228

Installer Menu Options i-on Range
Page 50
Naming Expanders
The control unit allows you to give each expander a name (see page 138 for
detailed instructions). The name appears in the log, in alerts, and when
programming the expanders.
Partitions (Allocating to Expanders)
You can assign each expander to one or more partitions. When assigned to a
partition an expander will:
Give notification tones for the associated partitions through the expander‘s
loudspeaker (if one is connected).
Control the response to tampers for the associated partitions. If any
associated partition is set then a tamper will cause an unconfirmed alarm. If
there is an outstanding unconfirmed alarm then this will cause a confirmed
alarm to be generated.
When delivered from the factory, or if you restore the control unit to factory
settings, then all expanders will belong to partition 1.
Once you have entered the Edit Expander - Partitions option, press

or

to
scroll through the list of partitions followed by

or

to allocate/deallocate
the expander to each partition as necessary.
If you wish to allocate/deallocate the expander to many partitions you can use
the ―All Partitions‖ option (in between the first and last partitions on the menu)
to either allocate or deallocate the expander to all partitions in one operation.
Once you have carried out this operation you can then scroll through the
partition list and change the allocation of expanders as necessary (you must
assign the expander to at least one partition).
Expander Loudspeaker Volume
To change the volume of notification tones from loudspeakers attached to
expanders use the
Detectors/Devices – Wired Expander – Edit Expander –
Loudspeaker volume
menu. Press

to lower the volume or

to raise the
volume. The display shows the current volume setting by a row of stars (for
example ―****‖). This volume control does NOT change the volume of alarm
tones, the control unit will still give these at full volume.
Press

to leave the menu.
Note: When you first add an expander to the bus, the control unit defaults the
loudspeaker volume to zero.
Wired Expanders Zone Wiring
You can change the zone wiring method for each wired expander individually.
During commissioning the Installer can select a system-wide zone wiring
method as part of the initial power-up (see the relevant Installation Manual). If
you wish to change the zone wiring method for an individual Expander use the
Detectors/Devices – Wired Expander – Edit Expander – Wired Zone Type
menu. See
page 140 for detailed instructions.
The zone wiring types available are: 4-wire CC, 2-wire CC, 2k2/4k7, 1k0/1k0,
2k2/2k2, or 4k7/4k7.