Cooper Security i-On 40, Инструкция по эксплуатации

Страница: 141 / 228

i-on Range Step by Step Programming Procedures
Page 131
To Manually Default The Bus Address Of A Keypad
1. Open the keypad (make sure that the keypad
tamper operates).
2. Apply 12Vdc power to the device (use the 0V
and 12V terminals on the keypad connector).
3. Hold down keys D and

at the same time. See Note below.
After a few seconds you should hear a
confirmation tone and the navigation LEDs
start flashing.
4. Release the D and

keys.
5. Close the lid, making sure the tamper switch
closes.
Note: DO NOT hold down D and

to delete a keypad from a system while the
keypad is still connected to the bus. Always delete keypads from an i-
onEX system first by using the Installer Menu, see page 133. If you have
inadvertently erased a keypad’s address by holding down D and

then:
1. Make the control unit re-scan the bus by leaving the Installer Menu.
2. Press

when the control unit displays ―Accept all changes to bus?‖.
3. Add the keypad back to the system, as described below.
To Add An Expander Or Keypad To The Bus:
30 50 160
1. Make sure that the expander or keypad has
the default bus address. (See page 130.)
2. Power down the system and connect the
device to the bus.
3. Power up the system.
4. Enter Installer Menu.


5. Press

.
The display shows:


6. Press

until the display shows


(The rest of these instructions assume you are
adding a wired expander. The same
instructions will also work for a radio expander
or wired keypad.)
8. Press

.
The display shows a message telling you to
press the address request buttons on the bus
device.

