Cooper Security i-On 40, Инструкция по эксплуатации

Страница: 75 / 228

i-on Range Installer Menu Options
Page 65
Type:
(nn=shortcut) Active when: Assign to
Partitions?
General Fault
(19)
There is any event that causes an alert
indication on the keypad. This includes:
RF Low Battery, RF Supervision, RF
Jamming, AC Fail, Battery Fault, PSU Fault,
Tamper, Masking. Note that a General
Fault output will trigger within a few
seconds of an AC Fail, and is NOT affected
by the Mains Fail delay setting.
Yes
ATS Test (20)
30 40 50
160
(This output type appears only for Plug-by
outputs.) The line fault input signal goes to
12V. The output remains active for one
second. The operation of the Line Fault
input and the ATS test output complies
with the requirements of BSIA form 175.
No
Siren (21) The control unit starts a full alarm, a hold
up alarm or a fire alarm (the siren has a
distinctive tone during a fire alarm). The
control unit deactivates this output at the
end of the siren time. See page 75 to
choose the siren duration.
Yes
Strobe (22) a) The control unit starts a Full alarm, hold
up alarm or fire alarm. The output remains
active until the user disarms the system.
b) Setting or unsetting, if you have
selected ―strobe on set‖ and/or ―strobe on
unset‖, see pages 74 and 74.
Yes
Entry Exit Follow
(23) The entry or exit time starts and
deactivates at the end of the entry/exit
time, or if the entry/exit time is
terminated. The output can be used for a
separate entry/exit buzzer. Note that the
output does not operate if the exit mode is
silent set or instant set.
Yes
Armed (24) The system (or partition) is full or part set. Yes
PIR Set Latch
(25)
30 40 50
160
The system or partition is set. Inactive
when the system or partition is unset or an
alarm condition occurs. The output is
active for one second when a reset is
performed or when the control unit leaves
installer mode.
Note: By default this output is at +12V
when active and 0V when inactive.
Use the Inverted attribute if you wish
to change this behaviour.
Yes