Cooper Security i-On 40, Инструкция по эксплуатации

Страница: 27 / 228

i-on Range Basic Programming Procedures
Page 17
1. If possible, enter the Installer menu.


Note: If you cannot enter Installer Menu then the
control unit will start a tamper alarm when you
open its lid.
2. Remove mains power, then open the control
unit and disconnect all batteries.
Note: This procedure will not work if the control
unit lid tamper remains closed.
3. Identify the Reset Codes pins on the main PCB
(see the relevant Installation Guide ).
4. Short the Reset Codes pins together using a
small screwdriver or jumper link. (Keep the
short on until step 6.)
5. Apply mains power.
The control unit loads the factory default
access codes:
Grade 2: User 01=1234, Installer=7890.
Grade 3: User 01=123456, Installer=567890.
(Note that i-on30EX and i-on40 are Grade 2
only.)
The control unit starts a tamper alarm. After a
pause of several seconds the keypad display
shows the time and date. (On i-onEX control
units the keypad display shows first the
software revision of the keypad and then the
words ―Please wait...‖ during the pause.)
The red LEDs glow to show an alert that the
control unit lid is open.
6. Remove the short from the Reset pins.
7. Reconnect the batteries.
8. Close the control unit lid (to restore the
tamper switch).
The display shows the time and date, for
example:


9. Key in the default User 01 code to silence the
sounders.
The display shows:


10. Enter Installer Menu and then leave it again.
The LEDs around the navigation key should
now be green. If they glow red then there may