Cooper Security i-On 40, Инструкция по эксплуатации

Страница: 170 / 228

Step by Step Programming Procedures i-on Range
Page 160
WAMs
30 40 50 160
Please read the installation manual for the WAM. You must make sure that the
WAM is programmed as Mode 1 BEFORE adding it to the system. The WAM
must be powered up in order to make the control unit learn its identity.
Adding a WAM
To teach the control unit the WAM‘s identity:
1. Enter Installer Menu.


2. Press

.


3. Press

until the display shows:


4. Press

.


5. Press

.
On an i-onEX range control unit the bottom line
of the display shows the first of the available
radio expanders.


On an i-on40 control unit the bottom line of the
display shows:
Go to step 8.


6. Press

or

to select the expander that you
wish allocate the WAM to.
Note: This example assumes that your radio
expanders are bus devices 02 and 05. The
numbers may be different on the system you
are working on.


7. Press

.
The display shows the first in a list of the
available WAM device addresses on the
selected expander. When a device address is
occupied with a WAM then the bottom line
shows a ―*‖ at the beginning and the WAM
name.

