Cooper Security i-On 40, Инструкция по эксплуатации

Страница: 217 / 228

i-on Range Appendix IV
Page 207
The bottom line of the display shows the
outputs current type.
8. Press

or

until the display shows the
output you wish to add, for example:


9. Press

.
The display prompts you to make sure that
the receiver is in learn mode:


10. Press

.
The control unit transmits its identity to the
receiver. When the receiver has successfully
learned the identity of the control unit it
beeps twice.


At the 762r (or 768r/769r)
The 762 or 768r/769r gives a double ―beep‖ and the display shows the
device number allocated to the transmitter. If you are using radio learn
the display alternates with the transmitter‘s signal strength, for example:
D2 S7 
(If you are using Infra-red learn the display shows a signal strength
reading of zero.)
Note: If the display shows "--" and you hear a low tone from the sounder, then
the 762r has already learned that transmitter.
If you hear a double beep followed by a low tone then the 762 has
insufficient channels available for all the channels transmitted, but has
allocated to the transmitter those that are available.
1. Press Esc/Del to go back to the command menu.
The display shows:
Ln
2. Press Select until the display shows the command "GO".
You should see:
GO
3. Press Set.
The display shows:
CL
You should hear a single beep repeated slowly.
4. Close the lid.
The unit is now out of programming mode.
Note: There is a deliberate delay of four seconds before the receiver leaves
programming mode. This is to make sure that you have time to close the
lid properly and screw it down firmly.