Cooper Security i-On 40, Инструкция по эксплуатации

Страница: 176 / 228

Step by Step Programming Procedures i-on Range
Page 166
16 40 On an i-on16 or i-on40 control
unit the bottom line of the display shows the
type assigned to the output.
Go to step 9.


30 50 160
7. Press

or

to select the expander that you
wish allocate the radio output to.
Note: This example assumes that your radio
expanders are bus devices 02 and 05. The
numbers may be different on the system you
are working on.


30 50 160
8. Press

.
The display shows the first in a list of the
radio outputs for the selected expander. The
bottom line of the display shows the current
type of the output.


9. Press

or

until the display shows the
output you wish to edit, for example:


10. Press

.


11. Press

.
The bottom line of the display shows the
output‘s current type. A ―*‖ at the beginning
of the line is there to remind you of the
current type if you scroll down the type list. .


12. Press

or

to scroll through the type list.
You can select any of the types listed on page
61 onwards.
You can select an output type quickly by
keying the number shown in brackets after
the type‘s name, for example:―04‖ to select
Open/Close, ―02‖ to select Hold Up Alarm,
―19‖ to select General Fault. The number does
not appear on the keypad display.


13. Press

to confirm the change in type.

