Cooper Security i-On 40, Инструкция по эксплуатации

Страница: 109 / 228

i-on Range Installer Menu Options
Page 99
To program how the control unit will communicate with an ARC select
Communications - ARC Reporting
.
Call Mode
To choose the call mode for communicating with an ARC select:
Communications
– ARC Reporting – Call Mode
. The call modes available are:
Disabled.
The control unit disables all ARC communications.
Note: If you have fitted an 8750 module to the control unit then the module
will continue to send Poll calls to the ARC even if you set call mode to
disabled. (The ARC will not receive alarm or test calls.) If you also
disconnect the Ethernet cable from the 8750 module the control unit will
not raise a Line Fail or Poll Fail alert, because you have set the call mode
to disabled.
Single.
The control unit reports to the first telephone number in the Phone Book,
using a single account number (see "Account Numbers" on page 100).
Operation: The control unit dials the number and attempts to connect with
the ARC. If the call fails, the control unit ends the call and then re-
attempts to connect up to a maximum of 15 times.
Alternate.
The control unit reports to one of the two telephone numbers in the Phone
Book.
Operation: The control unit dials the first telephone number and attempts
to connect to the ARC. If it fails, it will then close down and dial the
second telephone number and attempt to connect to the ARC. If received
and acknowledged on this attempt, the alarm transmission is complete. If
the control unit fails to connect to the second telephone number, it will
close down again and re-attempt to connect to the first telephone
number. The control unit will continue to shuttle between the two
numbers up to 15 times.
Phone Book
This option does NOT appear if a GPRS or Ethernet module is fitted. Use this
menu to store two telephone numbers that the control unit uses to report
alarms to the ARC. The control unit accepts one telephone number if you
choose Single in the Call Mode menu, or two telephone numbers if you select
Alternate in the Call Mode menu.
The control unit can store telephone numbers up to 31 digits long.
Use the

and

keys to move the cursor backwards and forwards through
the number if you wish to edit it.
Press

to delete the digit to left of the cursor.
Press * to add a 2 second pause, if required. The display shows this as a
comma.