3-16
INSP
ADJ
E
LOWER UNIT/GENERAL
Lower unit leakage check
1. Check:
9
Pressure
Pressure drops
→
Inspect the oil seals
and components.
Checking steps:
8
Connect the leakage tester to the oil
level checking hole.
8
Apply the specified pressure.
8
Check that the lower unit holes the
specified pressure for ten seconds.
NOTE:
Do not overpressurerize the lower unit.
Excessive pressure may cause the air to
leak out.
GENERAL
Anode
1. Inspect:
9
Anode (engine)
9
Anode (lower unit)
Scales
→
Clean.
Oil/grease
→
Clean.
Excessive wear (half worn)/damage
→
Replace.
c
C
Do not oil, grease or paint the anode, or it
will not operate properly.
Leakage tester:
YB-03595/90890-06762
Pressure:
100 kPa (1.0 kg/cm
2
, 14.2 psi)
Trim tab check (for S-transom model)
1. Inspect:
9
Trim tab
Damage/cracks/bends
→
Replace.
