Section 8: Appendix
TG3 Series Service Manual
Page 8-15
8.9 TAG SORTING METHOD (Cont’d)
8.9.2 Separator
Separator is used for the tag (Center hole, Side hole, Edge (Notch) and I-mark) and it becomes available
when the cutting motion is activated. The following print operation will occur when receiving the batch
separator command (ESC I2) under the receive command.
Important:
This (ESC I2) command cannot issue the second tag in long format. Please do not attempt to specify the print
quantity [QTY=1] more than twice in a row. If so, a print error may occur.
It is possible to specify the print of batch separator after printing the tag (QTY>=1) by the separator.
Pitch sensor
Printhead
Cut position
Before printing
Print operation
Separator
activated
Discharges
the tag
Backfeed motion
Summary of Contents for TG308
Page 1: ...Service Manual For printer model TG3 Series www satoamerica com PN 9001226 A...
Page 6: ...Table of Contents Page iv TG3 Series Service Manual This page is intentionally left blank...
Page 7: ...Section 1 Introduction TG3 Series Service Manual Page 1 1 INTRODUCTION...
Page 251: ...Section 9 Sato Group of Companies TG3 Series Service Manual Page 9 1 SATO GROUP OF COMPANIES...