Section 7: Replacement Procedures
Page 7-40
TG3 Series Service Manual
7.26 REPLACING CUTTER MOTOR
1.
With the power supply is off, lift up the
main cover
.
2.
Detach the
Cutter unit
according to the procedures in
Section 7.23 Replacing Cutter Unit
.
3.
Disconnect the
Motor connector
(1) from the
Cutter PCB
.
4.
Detach the
Cutter front cover
by removing three
screws
(2) on the top and two
screws
(2) on each side.
5.
Remove two
screws
(3) securing the
cutter motor
(6) from the
cutter unit frame
.
6.
Using a
Hex wrench
, remove two
Hex socket set screws
(4) to detach the
Pulley(24)
(5) from the
motor
shaft
.
7.
Withdraw the defective
Cutter motor
(6) and replace it as necessary.
8.
Reverse the above procedures for reassembly.
Insert the
wiring harnesses
firmly and arrange the
wiring harnesses
to ensure that they are not pinched
during installation.
9.
After replacement, adjust the timing belt tension based on
Section 6.20 Adjusting Cutter Motor Timing
Belt Tension
.
ƻ
Remove the Motor connector as indicated
by .
3
2
4
2
2
1
6
5
Summary of Contents for TG308
Page 1: ...Service Manual For printer model TG3 Series www satoamerica com PN 9001226 A...
Page 6: ...Table of Contents Page iv TG3 Series Service Manual This page is intentionally left blank...
Page 7: ...Section 1 Introduction TG3 Series Service Manual Page 1 1 INTRODUCTION...
Page 251: ...Section 9 Sato Group of Companies TG3 Series Service Manual Page 9 1 SATO GROUP OF COMPANIES...
