SATO TG308, Service Manual

Page: 95 / 252

Section 4: Operation and Configuration
TG3 Series Service Manual
Page 4-55
4.12 TEST PRINT MODE
(
Cont’d)
Item name to be printed Description
Check The setting of calendar check.
“Enabled” will be printed if calendar check is on. If not, “Disabled”
will be printed.
Note that this information will not be printed without installing the
calendar IC.
Cmd Err (Command Error) The setting of command error display.
“Error” will be printed if this setting is enabled. If not, “Warning” will
be printed.
P-Code (Protocol Code) Protocol code setting.
For standard protocol, “Standard” will be printed. For non standard
protocol, “Non Standard” will be printed.
Also, the protocol code stored in the printer will be printed.
Euro Code Euro code setting.
I/F-1 Interface setting.
If the interface is not connected, “----” will be printed.
I/F-2 Connection status with Keypad.
If the Keypad is connected, “Keypad” will be printed. If not, “-----”
will be printed.
Pitch (LCD) Print position specified via LCD display will be printed.
Offset (LCD) Cut position specified via LCD display will be printed.
Darkness (LCD) Print darkness specified via LCD display will be printed.
FRM1 CHK SUM Checksum value in firmware area.
(A): Checksum including firmware and built-in fonts.
(P): Checksum including firmware only.
Note that checksum value may change by firmware version.
FRM2 CHK SUM Extended memory, LCD data, UNICODE conversion table, check-
sum value of TTF header area. Note that checksum value may
change by destination.
FRM3 CHK SUM Checksum value of TTF/ outline font.
Checksum value when TTF/ outline font is not registered will be
“0000”.
Note that checksum value may change by destination.
FRM4 CHK SUM Checksum value of Kanji ROM area. Note that checksum value
may change by destination.
Checksum value without Kanji ROM will be “0000”.