SATO TG308, Service Manual

Page: 186 / 252

Section 7: Replacement Procedures
Page 7-2
TG3 Series Service Manual
7.1 REMOVAL OF HOUSING COVER
Before remove the casing of the printer, turn Off the power of the printer. Disconnect all the cables attached to
the printer. If you need to remove the CONT board (main PCB), disconnect the attached interface card.
7.1.1 To remove Main cover
1.
Lift up the
main cover
. From the two sides of the cover
joint, lightly push from inside outwards and then leave up to
remove.
7.1.2 To remove the left housing cover
2.
Base on the
Media ejection slot
as the front, locate the
large
housing cover
that is the left-most panel. Locate the
two
screws
at the bottom part of this panel or cover. With a
Phillips screwdriver, remove these two
screws
.
3.
From the bottom of the printer,
lift the cover
upward as
shown and remove the cover.
7.1.3 To remove the top left housing cover
4.
Unscrew 5
screws
as indicated and remove the left housing cover from the printer.
Main cover
Media
ejection slot
screws
Top left cover