Section 4: Operation and Configuration
TG3 Series Service Manual
Page 4-53
4.12 TEST PRINT MODE
(
Cont’d)
2)
Second piece
-- Setting values in Service Mode, sensor information, VR (Potentiometer), offset values for
each paper type will be printed.
Item name to be printed
Description
Reflective Sensor
Low [Lo<1.0] x.x(V)
High [0.8<Hi-Lo] x.x(V)
Slice Level Auto
This information will be printed when reflective sensor is enabled.
*Setting value will not be indicated in reverse colors.
Transmissive Sensor
Low [0.2<Lo<1.0] x.x(V)
High [0.8<Hi-Lo] x.x(V)
Slice Level Auto
This information will be printed when transmissive sensor is
enabled.
*Setting value will not be indicated in reverse colors.
Priority
The validity of priority setting.
“Command” will be printed when this setting is available. If not,
“Internal” will be printed.
Print Area
Print area setting supported in the existing model “XL4xxe”.
“Enabled” will be printed when this setting is available. If not, “Dis-
abled” will be printed.
Stacker
The validity of stacker/ rewinder status detection. “Enabled” will be
printed when this function is on. If not, “Disabled” will be printed.
Nonlock
The validity of ribbon nonlock detection.
“Enabled” will be printed when this function is on. If not, “Disabled”
will be printed.
F-Pitch (VR)
Pitch offset value for factory default in “mm” scale.
Pitch (VR)
Pitch offset value in “mm” scale.
Offset(VR)
Offset value for cut position in “mm” scale.
Darkness (VR)
Print darkness setting value.
Pitch
Cut
Back
Slice
Tag/Label stop position, cut position, backfeed distance, and sen-
sor slice level.
[T C] = Center hole tag
[T I] = I-mark tag
[T S] = Side hole tag
[T E] = Edge tag
[L G] = Gap label
[L I] = I-mark label
[N S] = Sensor disabled
[Pitch] = Paper stop position
[Cut] = Paper cut position
[Back] = Backfeed distance
[Slice] = Sensor slice level
Summary of Contents for TG308
Page 1: ...Service Manual For printer model TG3 Series www satoamerica com PN 9001226 A...
Page 6: ...Table of Contents Page iv TG3 Series Service Manual This page is intentionally left blank...
Page 7: ...Section 1 Introduction TG3 Series Service Manual Page 1 1 INTRODUCTION...
Page 251: ...Section 9 Sato Group of Companies TG3 Series Service Manual Page 9 1 SATO GROUP OF COMPANIES...