SATO TG308, Service Manual

Page: 111 / 252

Section 4: Operation and Configuration
TG3 Series Service Manual
Page 4-71
4.16 FACTORY MODE (Cont’d)
FACTORY MODE
Menu Description
Use this to enter the revision number of the main PCB.
Use the
/ arrow
buttons to move the cursor.
Enter the revision number with the
/ arrow
buttons, and press
FEED
.
The initial value is 0.0.
You cannot clear this setting by resetting the counter.
Use this to enter the revision number of the interface board.
Use the
/ arrow
buttons to move the cursor.
Use the
/ arrow
buttons to enter the revision number, and then press
FEED
to set value.
The initial value is 0.0.
You cannot clear the setting by resetting the counter.
Select to activate the Factory Test Print function.
Move the cursor using the
/ arrow
buttons, and press
FEED
to confirm the
selection.
The initial value is NO.
Select paper type for test print.
Press
/ arrow
buttons or PAPER to select paper type, and press
FEED
to
save setting.
While PAPER SELECT is displayed, pressing the
CUTTER
button will set the
cutter motion.
Select factory test print size.
Move the cursor with the
/ arrow
buttons, and press
FEED
to select the
size.
SMALL...Prints the test pattern in 1.18 in. (3 cm) width.
LARGE...Prints the test pattern in 3.15 in. (8 cm) width.
The initial value is LARGE.
Select ink roller motion during test print.
Press
/ arrow
buttons to select the ink roller motion, and press
FEED
.
NO.......No ink roller action will be taken.
YES.....Ink roller action will be taken.
The initial value is NO.
This function is available only when paper type is tag.