Section 7: Replacement Procedures
Page 7-30
TG3 Series Service Manual
7.18 REPLACING JUMP HOLE SENSOR (cont’d)
To replace Jump hole sensor (lower) board
10.
Slide the Media guide knob to the widest. Remove two
screws
(10) securing the
Bracket (Jump sensor)
(11) to the Media route frame.
11.
Disconnect the
Lower Jump hole wiring harness
and withdraw the
Bracket (Jump sensor)
(11) with the
sensor board attached.
12.
Remove two
screws
(12) securing the
Lower Jump hole sensor board
(13) and replace it as necessary.
13.
Reverse the above procedures for reassembly.
Insert the
wiring harness
firmly and arrange the
wiring harnesses
to ensure that they are not pinched
during installation.
14.
After replacement, adjust the Jump hole sensor condition based on
Section 6.9.5 Jump hole Sensor
Sensitivity Adjustment
.
10
12
13
11
13
11
Summary of Contents for TG308
Page 1: ...Service Manual For printer model TG3 Series www satoamerica com PN 9001226 A...
Page 6: ...Table of Contents Page iv TG3 Series Service Manual This page is intentionally left blank...
Page 7: ...Section 1 Introduction TG3 Series Service Manual Page 1 1 INTRODUCTION...
Page 251: ...Section 9 Sato Group of Companies TG3 Series Service Manual Page 9 1 SATO GROUP OF COMPANIES...
