Section 4: Operation and Configuration
Page 4-50
TG3 Series Service Manual
4.12 TEST PRINT MODE
(
Cont’d)
4)
Fourth piece
-- Sensor information, interface information and the setting values for screen adjustment will
be printed.
Item name to be printed
Description
Command Error
The setting of command error display.
“Error” will be printed if this setting is enabled. If not, “Warning” will
be printed.
Protocol Code
Protocol code setting.
For standard protocol, “Standard” will be printed. For non standard
protocol, “Non Standard” will be printed.
Also, the protocol code stored in the printer will be printed.
Euro Code
Euro code setting.
DSW1
DSW setting on CONT board (Main PCB).
DSW2
When RS-232C interface board is connected, the DSW informa-
tion on the interface board will be printed.
JP9
JP9 on CONT board (Main PCB).
“0” must be selected for this setting.
Item name to be printed
Description
Reflective Sensor
Low [Lo<1.0] x.x(V)
High [0.8<Hi-Lo] x.x(V)
Slice Level Auto
This information will be printed when reflective sensor is enabled.
If “Low” is not [Low < 1.0], “Low” will be indicated in reverse colors.
If “High” is not [0.8 < (High-Low)], “High” will be indicated in
reverse colors.
Transmissive Sensor
Low [0.2<Lo<1.0] x.x(V)
High [0.8<Hi-Lo] x.x(V)
Slice Level Auto
This information will be printed when transmissive sensor is
enabled.
If “Low” is not [0.2 < Low < 1.0], “Low” will be indicated in reverse
color.
If “High” is [0.8 < (High-Low)], “High” will be indicated in reverse
colors.
I/F-1
Interface setting.
If the interface is not connected, “----” will be printed.
I/F-2
Connection status with Keypad.
If the Keypad is connected, “Keypad” will be printed. If not, “-----”
will be printed.
Pitch(LCD)
Print position specified via LCD display will be printed.
Offset(LCD)
Cut position specified via LCD display will be printed.
Darkness (LCD)
Print darkness specified via LCD display will be printed.
FROM1 CHECK SUM
Checksum value in firmware area and CODE39 barcode.
(A): Checksum including firmware and built-in fonts.
(P): Checksum including firmware only.
Checksum value may change by firmware version.
Summary of Contents for TG308
Page 1: ...Service Manual For printer model TG3 Series www satoamerica com PN 9001226 A...
Page 6: ...Table of Contents Page iv TG3 Series Service Manual This page is intentionally left blank...
Page 7: ...Section 1 Introduction TG3 Series Service Manual Page 1 1 INTRODUCTION...
Page 251: ...Section 9 Sato Group of Companies TG3 Series Service Manual Page 9 1 SATO GROUP OF COMPANIES...