SATO TG308, Service Manual

Page: 127 / 252

Section 5: Troubleshooting
TG3 Series Service Manual
Page 5-7
5.1 ERROR SIGNAL TROUBLESHOOTING (Cont’d)
5.1.3 Warning Message
Note that the printer will continue issuing tag/label while detecting a warning message.
No. WARNING DISPLAY LED BUZZER ERROR CONDITION CORRECTIVE ACTION
01
RIBBON NEAR END ONLINE:
On
ERROR:
Off
- 1) Remaining ribbon length
becomes short.
To clear error: Head open
(Ribbon replacement)
1) Change ribbon.
02 BUFFER NEAR FULL ONLINE:
On
ERROR:
Off
- 1) Free space for receive
buffer is low.
To clear error: Cancel print
operation or Data to create
more than 1.95MB free space
in receive buffer
1) Cancel print operation or data
to create more than 1.95MB free
space in receive buffer to clear
an error.
03 COMMAND ERROR ONLINE:
On
ERROR:
Off
1 short
Beep
1) Detecting improper com-
mand in print data.
2) Print data is outside the
printable area.
• This screen appears only
when command error dis-
play is disabled in
Advanced Mode.
To clear error: Normal data
reception
1) Check data
2) Adjust print data and base
reference point offset not to
exceed the printable area.
04 ONLINE:
On
ERROR:
Off
- 1) This message will be dis-
played after detecting and
clearing an electrical dis-
connection error of print
head temporarily with the
FEED button.
To clear error: Power Off
(Print head replacement)
1) Print head replacement
05 ONLINE:
Off
ERROR:
Off
- 1) The reference position is
changed by the <#> com-
mand.
• This warning appears only
when [ADJUST FEED
ACTION] is set to “STOP”
in Advanced Mode, paper
type is tag and cutter
motion is “ON”.
To clear error: Press ONLINE
button.
1) Remove a tag and press the
printer and press ONLINE
button. Or set [ADJUST FEED
ACTION] to “CONTINUE” in
Advanced Mode.