SATO TG308, Service Manual

Page: 33 / 252

Section 3: Interface Specifications
TG3 Series Service Manual
Page 3-13
3.6 WIRELESS LAN ETHERNET (Cont’d)
3.6.1 Basic Specifications (Cont’d)
DSW DSW is a maintenance switch to initialize the configuration saved on the wireless
LAN board, to print the configuration, and to set wireless LAN communication
mode.
<Important>
1) Make sure to set all the DSW to “OFF” when you use the printer.
2) Make sure to set [DSW1] to “OFF”.
DSW Operation when turning the printer on while DSW is ON
1 Not used (Setup prohibited)
2 LAN board EEPROM initialization (Initializing configura-
tion)
3 Print of self-diagnosis (Prints the examination result of
board on a label)
Print of configuration (Prints configuration details such as
an address)
4 Wireless mode switching (OFF: Ad hoc / ON: Infrastruc-
ture)
Interface selection Wireless LAN interface and the LAN interface are provided as a combo board.
Turn on the printer without connecting the LAN cable.
Communication setup The following communication settings are available in the Interface Mode of the
printer.
Item Setting range
Protocol STATUS3
STATUS4 (Cyclic response mode)
STATUS4 (ENQ response mode)
STATUS5
IP address 0.0.0.0 ~ 255.255.255.255
Subnet mask 0.0.0.0 ~ 255.255.255.255
Gateway address 0.0.0.0 ~ 255.255.255.255
Communication mode 802.11 Ad hoc
Infrastructure
SSID Optional alphanumeric character string
(Up to 32 characters)
Channel 01 ~ 14
* IP address, Subnet mask, Gateway address are settable in [Admin Manager],
the utility of attached CD-ROM, and communication mode is settable by the DSW
of interface board. In this case, each setting value is saved to the interface board
directly. Go to [LAN Configuration] of Interface Mode to enable the setup either by
the one mentioned above or by the Interface Mode.