SATO TG308, Service Manual

Page: 238 / 252

Section 8: Appendix
Page 8-8
TG3 Series Service Manual
8.6 OFFSET POSITION ADJUSTMENT
The offset function (print, cut and backfeed) of the printer are as follows.
8.6.1 Adjustment of Print Position
Adjustment screen Mode: Pitch P/-0.15” (3.75 mm) for all media types
Online command (ESC #)+/-2” (50 mm) for each media when received
Service Mode: Pitch /-99dot for each media
8.6.2 Adjustment of Cut Position
Adjustment Mode: Offset P/-0.15” (3.75 mm) for all media
Online command (ESC #)+/-2” (50 mm) for each media when received
Service Mode: Cut /-99dot for each media
Print or cut operation will be performed by the value of which each item is added at every single job.
The default values in Service mode
Item
TG308
(203 dots per
inch or 8 dots
per mm)
TG312
(305 dots per
inch or 12
dots per mm)
Adjusting stop position Tag Center hole +00 +00
Side hole +00 +00
Edge +00 +00
I-Mark -12 -18
Label Gap -12 -18
I-Mark -36 -54
Adjusting cut position Tag Center hole +00 +00
Side hole +00 +00
Edge +00 +00
I-Mark -12 -18
Label Gap -12 -18
I-Mark -36 -54
Sensor off +00 +00
Adjusting backfeed distance Tag Center hole +00 +00
Side hole +00 +00
Edge +00 +00
I-Mark +00 +00
Label Gap +00 +00
I-Mark +00 +00
Sensor off +00 +00