Section 7: Replacement Procedures
TG3 Series Service Manual
Page 7-41
7.27 REPLACING OPTIONAL STACKER PCB (ST-TG3)
1.
Before proceeding, switch off the printer and remove the optional Stacker unit installed at the front of the
printer.
2.
On the left side of the stacker unit, remove five
screws
(1) to detach the
Cover (LH)
(2) as shown.
3.
Remove two
screws
(3) securing the
Stacker PCB
(4) to the
stacker unit frame
.
4.
Disconnect the two
wiring harnesses
from the defective
Stacker PCB
(4) and replace it as necessary.
5.
Reverse the above procedures for reassembly.
Insert the
wiring harnesses
firmly and arrange the
wiring harnesses
to ensure that they are not pinched
during installation.
2
1
4
3
1
4
3
Summary of Contents for TG308
Page 1: ...Service Manual For printer model TG3 Series www satoamerica com PN 9001226 A...
Page 6: ...Table of Contents Page iv TG3 Series Service Manual This page is intentionally left blank...
Page 7: ...Section 1 Introduction TG3 Series Service Manual Page 1 1 INTRODUCTION...
Page 251: ...Section 9 Sato Group of Companies TG3 Series Service Manual Page 9 1 SATO GROUP OF COMPANIES...
