Section 7: Replacement Procedures
TG3 Series Service Manual
Page 7-15
7.9 REPLACING TIMING BELT (PLATEN) (cont’d)
6.
Loosen the adjustment screw of
tension bracket
as shown, if necessary. And remove the
Timing belts
in
numerical order from (5) to (10) for replacement.
These are the
Timing belt M266
(5),
Timing belt M290
(6),
Timing belt M284
(7),
Timing belt M386
(8),
Timing belt M214(203dpi)
/
Timing belt M250(305dpi)
(9),and
Timing belt M194(203dpi)
/
Timing belt
M230(305dpi)
(10).
7.
Reverse the above procedures for reassembly.
8.
After replacement, adjust the ribbon tension according to the procedure in
Section 6.19 Adjusting Timing
Belt Tension
.
CAUTION:
A PROPERLY TENSIONED BELT WILL BE JUST ENOUGH TO PREVENT SLIPPAGE.
AN OVERLY TENSIONED BELT WILL EXCESSIVELY INCREASE DRAG ON THEIR
PULLEYS AND INCREASE COMPONENT WEAR.
tension bracket
tension bracket
5
6
7
8
9
10
Summary of Contents for TG308
Page 1: ...Service Manual For printer model TG3 Series www satoamerica com PN 9001226 A...
Page 6: ...Table of Contents Page iv TG3 Series Service Manual This page is intentionally left blank...
Page 7: ...Section 1 Introduction TG3 Series Service Manual Page 1 1 INTRODUCTION...
Page 251: ...Section 9 Sato Group of Companies TG3 Series Service Manual Page 9 1 SATO GROUP OF COMPANIES...
