Section 8: Appendix
Page 8-6
TG3 Series Service Manual
8.4 POSITIONS OF SENSORS AND OPTIONS
Only center hole sensor and Gap sensor are in common use. There is no interference among sensors shown
above.
89.1mm
(3.51”)
I-Mark
7.0mm (0.27”)
126.6mm
(4.98”)
67.4mm
(2.65”)
50.4mm
(1.98”)
176.6mm
(6.95”)
Edge (Notch)
2.5mm
(0.1”)
Center hole/ Gap
12.5 to 43.0mm
(0.49” to 1.69”)
Side hole
19.0 to 80.0mm (0.75” to 3.15”)
Side hole
19.0 to 80.0mm (0.75” to 3.15”)
Center hole/ Gap
12.5 to 43.0mm
(0.49” to 1.69”)
I-Mark
6.0mm (0.23”)
Edge
(Notch)
2.5mm
(0.1”)
Jump hole
13.5mm (0.53”)
Print head
Batch separator
23.0mm (0.9”)
Cutter sensor
23.0mm (1.6”)
Cutter blade
29.2mm (1.15”)
Feed roller
19.1mm (0.75”)
Summary of Contents for TG308
Page 1: ...Service Manual For printer model TG3 Series www satoamerica com PN 9001226 A...
Page 6: ...Table of Contents Page iv TG3 Series Service Manual This page is intentionally left blank...
Page 7: ...Section 1 Introduction TG3 Series Service Manual Page 1 1 INTRODUCTION...
Page 251: ...Section 9 Sato Group of Companies TG3 Series Service Manual Page 9 1 SATO GROUP OF COMPANIES...
